Measuretek PS-103-200 Specifications download pdf (Page 7)

3. OPERATIONS

Normal Weighing Mode

1. Power on the scale by pressing the ZERO/ON/OFF key.

2. When the display stabilizes, but it doesn’t show zero, press ZERO/ON/OFF to set a new zero point.

3. Place objects on the scale platform and read the weight on the indicator.

Note: Objects should be placed at the center of the platform. Corner or side loading heavy objects may risk

overloading an individual load cell and damage the scale.

Yes No No

4. To change the weight unit of measure, press the UNIT key.

5. To send data to another device via the serial port, press the PRINT/HOLD key.

6. To hold the weight data, press and hold the PRINT/HOLD key for 4 seconds.

7. Power off the scale by pressing and holding the ZERO/ON/OFF key for 4 seconds.

ZERO

If the display dose not shows 0, and there is nothing on the platter, press the ZERO/ON/OFF key to zero the reading.

Zero range: ±20% * full Capacity.

The zero function is unavailable when the displayed reading is out of the zero range and the indicator will show the

error message 0﹉﹉﹉ or 0﹍﹍﹍, meaning the scale is over or under zero range.

Setting a Tare Weight

1. Zero the scale as described above.

2. Place an empty container on the platform, press the TARE key. The display will return to zero, eliminating the weight

of the container. The NET announciator will be lit on the display.

3. Put the material or object to be weighed in the container. The net weight will be displayed.

4. To exit tare mode, remove all weight from the scale. The display will show a negative weight. Press the TARE key to

return the display to zero.

PS‐103 www.measuretek.net .5

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Measuretek PS-103-200 Specifications Page 7